tangspower 29.4V 2A Charger Output for 25.2V Hover Board 7Series Li ion Battery Pack 25.9V 24V 3pin XLR Male Connector Microphone Head

March 8, 2019 - Comment

Brand Name: Tangspower Quick charge: No Usage: standard battery Package: yes Battery Number: 7 series Type: electricity Smart Charging: Yes Screen display: No Socket Standard: RCA connector Whether original: original Apply to: lithium battery pack Input: 100-240V AC 50-60HZ Protections: Short circuit / Overload / Over voltage Plug: US LED Display: Red: In charging state,

Brand Name: Tangspower

Quick charge: No

Usage: standard battery

Package: yes

Battery Number: 7 series

Type: electricity

Smart Charging: Yes

Screen display: No

Socket Standard: RCA connector

Whether original: original

Apply to: lithium battery pack

Input: 100-240V AC 50-60HZ

Protections: Short circuit / Overload / Over voltage

Plug: US

LED Display: Red: In charging state, Green: Full Charged

Charge mode: CC to CV

Use: lithium battery pack charger

Use and maintenance of the charger :
1. When charging, first connector to the battery, then connect to AC; after full, cut off AC, then pull the battery plug.
If you pull the battery plug first while charging, especially when the charging current is large (red light), it is very easy to damage the charger.
2. When the LED light turns green, please continue charging for 2-3 hours.
3. Please do not run out of battery power, then charger. Otherwise the battery cannot be protected or even damaged.
4. long-term shallow discharge battery, about 3 months, for a deep discharge, is the so-called re-lighting, which is conducive
to the activation of long-term immobile material in the deep part of the battery. Luminous means that riding the controller battery undervoltage protection action.
5. If your battery has not been used for a long time (2-3 months), please charge the battery before using it. Make sure your battery is not broken.
6.Please use the charger in a dry place in time.
7.When you do not use the charger, do not always connect the power supply.
8.Please confirm your battery, Because it is used to charge the lithium battery. Do not use the charger on the LiFepo4
battery, otherwise the charger will be got incredibly hot.

Product Features

  • Output 29.4V 2A, World Wide Input Voltage 100-240VAC 50/60Hz
  • 105℃ Output capacitor, global applicable AC Input voltage.100% full load aging test, Internal EMI filter, ripple minimum.The precision current between ±0.1A, the voltage tolerance is ±0.1V, absolutely not virtual marking.
  • The charger Built-in simply fan, with radiating fin surrounding the board, dissipating the heat through the shell, So some hot on the shell when charging is very normal, but it is durable.
  • The Charger protected: Short circuit protection/ over current protection/ over voltage protection; red light — charging, green light — charge OK, it stop automatically when the battery is full.
  • Replace your broken charger or add an extra charger to charge in 2 locations without taking the original charger with you

Comments

Anonymous says:

Working good. Using this with a small DIY 18650 pack. Seems to hold the voltage right where needed. Using this without a bms since mine failed and I’m using older cells anyway. Haven’t tested with a 3.2v per cell pack, but it says it will auto-detect those as well. Doesn’t get hot, barely warmer than skin temp, but I’m only charging a 7s2p pack, doesn’t take long to charge.

Anonymous says:

Perfect fit!!! This cord was a perfect fit for my husbands scooter, he lost his charger, and I was thankful to find this one!!

Anonymous says:

Works Great Just what I needed works great

Comments are disabled for this post.